1734 Point I/O

Hydro Power Guy

Member
H
Join Date
Jun 2005
Location
Montreal, Quebec
Posts
252
I have a customer who wants to use terminals for field terminations even though the AB Point I/O RTB's are meant for this purpose. Has anyone ever run across a pre wired harness that connects Point I/O RTB's with terminals (phoenix, wiedmuller, etc...)?
 

Similar Topics

geniusintraining
Point IO 1734 and Micro800 L50E L70E
Anyone use the newer 2080-L50E or L70E with 1734 Point IO yet? I have a customer asking for a setup and I have not found anyone that has done...
Replies
0
Views
371
geniusintraining
geniusintraining
P
1734 point IO flashing red network and point bus lights
About every 5 minutes we are seeing both network and point bus status lights on our 1734-AENTR blink red simultaneously for about 30 seconds, then...
Replies
13
Views
1,421
robertmee
R
EICS
1734 -VHSC24 Point I/O High Speed counter wiring
i am bench testing a 1734 -VHSC24 Point I/O High Speed counter module, i cannot find any examples of wiring the outputs from the module. does...
Replies
4
Views
1,388
EICS
EICS
M
Dual IP address for 1734-AENT/B Point IO
Hello. My facility has Point IO modules (on a separate cabinet) which is connected to a controllogix PLC via 1756-EN2T module. We lost...
Replies
3
Views
1,406
Ken Roach
Ken Roach
S
1734-AENT Series C Point bus module
Hi, I just bought a 1734-AENT Series C module (Revision 6.01). I am using RS logix5000 and at site we have a running system with control logix...
2
Replies
16
Views
8,804
sandy5020
S
Back
Top Bottom