Config SLC 5/03 CH0 to DF1 (RS232)

Similar Topics

A
I/O Config SLC 5/03
So while investigating further the issues on my PLC, which is an SLC 5/03, I was scrolling around in the I/O Configuration under the Project Tree...
Replies
12
Views
2,853
Elons_Musk
E
P
Using a test SLC without proper I/O config
I'm pretty sure I know the answer to this, but thought I should ask. Over the years, when I'm given a SLC project, I'll load it in my test 5/05...
Replies
2
Views
1,394
phuz
P
C
SLC I/O Read Config
We installed a new rack today to one of our SLC 5/04 units. When we did the read IO config, it came back with some wierd settings I've never seen...
Replies
8
Views
2,809
OkiePC
OkiePC
L
Prosoft MVI69E-MBTCP - Config help
Hi, We have an application that has a device that goes through a reboot (appears un-graceful) What then happens is the MVI module appears to hang...
Replies
0
Views
73
lostcontrol
L
P
Siemens Scalance SC636-2C NAT config
Hi all, I have some difficulties with programming a NAT config in my Scalance SC636-2C When programming the NAT-table i'm not able to reach my...
Replies
4
Views
196
goghie
G
Back
Top Bottom