A-b 1745-pt1........help!

waggs

Member
Join Date
Mar 2004
Location
Yucaipa, CA
Posts
108
Hey Crew,
I know this has been knocked to death but I figure the quickest way to an answer is to ask the question again. I'm looking for a 1745-PT1 programmer and cable for a slc100/150 to beg, borrow or steal. Cheap (less than a $100) is acceptable too...(nice guy that I am). Hope someone can help me out.
Regards,

Waggs
 
Thanks for the help guys. I linked to eBay and actually have a bid in on one now...don't anyone dare outbid me...hahaha. Once again, the crew comes through. Many thanks.

Waggs
 

Similar Topics

Hello All, I am attempting to upload from a SLC 100. I know the controller is good because it is still in operation. I know the programming port...
Replies
4
Views
3,422
i located the sw on the ab site but i get an error. i think because the sw i down loaded is not actived. i could not locate a PCIS comm sw for the...
Replies
1
Views
1,958
So I bought a 1745-PCC-USB to replace the old cable. I installed the driver. I went to device manager reset the port to com 1. If I have the wrong...
Replies
18
Views
7,354
Looking for a troubleshooting manual for the above PLC controller. So far I have found this one which is of no help...
Replies
13
Views
5,500
I have an Allen Bradley SLC150 1745-LP152. What cable and software do I need to be able to download, edit, etc, the program? Is this possible...
Replies
4
Views
5,029
Back
Top Bottom