GSM connexion between FANUC station and Versamax PLC

teckhno2002

Member
Join Date
Nov 2005
Location
Craiova
Posts
35
I have an application developed with Cimplicity Machine Edition 5.0. This application must exchange data with PLC Versa Max. Distance between PLC and my application is 15 km. Because of this I must use two GSM modems (Westermo GDW-11).

My problem is: the modem has one port (RS 232). I want to write “AT “ commands from my application to modem, but the port RS 232 is used of by the communication drive (Modbus RTU), so I can’t stop and restore connection between modems.
 

Similar Topics

I recently purchased a GSM modem model number SGM510 from a local dealer in Mumbai, India and I am trying to connect it to a Delta PLC that I have...
Replies
0
Views
1,623
Hi, I have a Mitsubishi Alpha 2 Plc and am trying to link this to GSM Modem (Quasar Q2403R). With no success I am struggling with the following: 1...
Replies
7
Views
1,725
Hello Experts.... Could anyone guide me that in one application I have to send SMS data using GSM module & Micrologix PLC. By reading some...
Replies
0
Views
1,520
Dear you hope to receive your help, I need to make sending and receiving SMS messages between a ( AL2-24MR -A) Mitsubishi controller and GSM modem...
Replies
0
Views
2,579
I have a task where I need to send SMS with system problems alert through PLC. I think PLC is not matter. Let's say it have RS2323 and 485 on...
Replies
5
Views
2,076
Back
Top Bottom