Simple but work well

Guest

Guest
G
Dear all Plc Tutors,
May I share some simple plc circuit .
Normally this machine use 32 toggle switches to control by relays.
for example Sw. no.1 machine run in Speed A. tool No.1
Sw. no.2 machine run in Speed A. tool No.2
Sw. no.3 machine run in Speed A. tool No.3..
...............etc for 4 speeds and 6 tools.
The Last Sw. no.32 machine run in Speed D. tool No.6
When I use plc control (Mitsu) ..I use all those toggles sw.
at the output of PLC. and write program Sequencial funtion chart
for diff. 32 fungtion(may be can call 32 subroutines).
Yes..still work well for more than 6 years with the same fungtion
that user familiar with.
Anyway...Could you please give some idia about AB plc with thumwheel sw.in this case.
Thanks you very much.

platootod
 

Similar Topics

Hi all, Writng a FB in ST on Beckhoff TC for a pulser which turns on and off on a cycle, is paused by turning bControlInput to FALSE, but resumes...
Replies
4
Views
102
I'm trying to build my Classic Step 7 programming skills this weekend. I get stuck on little things that are not covered in YouTube tutorials. I'm...
Replies
7
Views
248
I have a program that does a 7 second "scan" sensor calibration routine whenever a setting (setting is called assistance level or "AL" and ranges...
Replies
3
Views
174
Hi all, I have a simple question that I have overcomplicated and gotten stuck on. I have a variable, we can call it "light" that I need to stay...
Replies
4
Views
216
Hi all! I am using unitronics Unistream plc, controlling two axis X and Y of polishing machine. Control is very simple as I have movement in each...
Replies
34
Views
3,688
Back
Top Bottom