Potter
Member
Is it possible to set the counters in a Mitsubishi Q series to retain there value when the power is switched off?
Mitsubishi Counter Question
- Thread starter Potter
- Start date
panic mode
Member
yes
panic mode
Member
ok, enough of being funny, go to parameters, devices and setup range you need latched.
see this post:
http://www.plctalk.net/qanda/showthread.php?p=162160#post162160
see this post:
http://www.plctalk.net/qanda/showthread.php?p=162160#post162160
Marc
Member
Are you using GX developer 8? If so open "parmeter" in the project tree and then open PLC parameter.
Click "device" tab this will show you the range of counter which are latched (retentive) on your processor. Either change the range or use counters in that range.
Marc
Click "device" tab this will show you the range of counter which are latched (retentive) on your processor. Either change the range or use counters in that range.
Marc
Similar Topics
I'm translating a printout of a program written for an F1/F2 series Mitsubishi PLC to a Micrologix.
I've stumbled upon something that I can't...
Hello all,
I don't know if its the football, the beer, or me, but I cannot figure out how to add a timer or counter in a rung using GX Works 2...
Does anyone know where I would find the programming manual for the Mitsubishi FX2n-1HC? I am using it with the FX3u plc.
Dear frnds.........
I m facing a problem in my project in mitsubishi plc fx2n 80mr. i want to back up my relay output . i mean i want them active...
Hello,
I'm trying to figure out what the Timer and Counter data types can be used for in Mitsubishi GX Works2. I can make Global Labels and...