Omron C2000h

Can somebody please advice whether the ladder program uploaded from OMRON C2000H PLC's using syswin will be compatible with the new range of OMRON PLC's.The orginal program which was on the C2000H was done using LSS.

Please give your expert opinion on this.Any comments would be appreciated.

Thanks in advance

Syswin is obsoleted and not compatable with the newer CPU's.

All you have to do is make sure you get any memory data along with the ladder logic. Then save it in syswin. Then in CX-Programmer you change the PLC type to a CJ or CS. If you use the right back plane with the CS many of the I/O modules for the C200 are direct plug and play. Any Remote I/O can remain the same with some address changes. C200 analog modules will not work with the CS.