catalin78
July 16th, 2006, 05:03 AM
i have a problem in a multiprocessor s5 sistem , the coordinator is
923 and cpus are 922 and 928 and i have a cp 516 installed too
after i power up , if i switch cp 516 to run both leds are lit run and stop , from the manual i read this may be a defective state ,
the cpus remain in stop after i switch the coordinator to run ,
i am supposing that cpus can't access memory module and they remain in stop.
If anybody knows something about this please give an opinion
is there some software for configuring this cp?
Thanks
923 and cpus are 922 and 928 and i have a cp 516 installed too
after i power up , if i switch cp 516 to run both leds are lit run and stop , from the manual i read this may be a defective state ,
the cpus remain in stop after i switch the coordinator to run ,
i am supposing that cpus can't access memory module and they remain in stop.
If anybody knows something about this please give an opinion
is there some software for configuring this cp?
Thanks