rgurin
Member
Greetings all, short-time responder, first-time posting question...
Has anyone been able to successfully communicate to a SoftLogix5 controller (software version of PLC-5) using RSView SE and RSLinx Enterprise?
I am creating a training scenario for a customer, and I was *hoping* to be able to simulate (in class) an Ethernet PLC-5 using SoftLogix5 instead of having to ship a PLC demo to the site. The customer is running a distributed RSView SE system, and has recently changed data servers from RSLinx Classic to RSLinx Enterprise.
In my test lab, I am banging my head against the wall trying to establish a connection between RSView Studio software and the SoftLogix5 controller.
I know that there is no problem communicating using RSLinx Classic, but this defeats the purpose. In RSLinx Enterprise, I can add a SoftLogix controller to the Ethernet driver, but whenever a browse occurs, the Softlogix device disappears, indicating that it is not being seen on the network.
Does anyone have any suggestions, or am I stuck with going the hardware route.
More details on the setup:
RSView SE version 3.2
SoftLogix v.2.1
SoftLogix Winsock32 TCP/IP driver installed.
Both machines (one running SoftLogix and one running RSView Studio) are on the same Ethernet subnet.
I attempted running all software from same machine, with unsuccessful communication as well. I tend to believe that the failure on the single computer is because I did not set up Linx Enterprise and Linx Classic to run side-by-side; not sure if this would help.
Let me know if you have any other questions.
Rick
Has anyone been able to successfully communicate to a SoftLogix5 controller (software version of PLC-5) using RSView SE and RSLinx Enterprise?
I am creating a training scenario for a customer, and I was *hoping* to be able to simulate (in class) an Ethernet PLC-5 using SoftLogix5 instead of having to ship a PLC demo to the site. The customer is running a distributed RSView SE system, and has recently changed data servers from RSLinx Classic to RSLinx Enterprise.
In my test lab, I am banging my head against the wall trying to establish a connection between RSView Studio software and the SoftLogix5 controller.
I know that there is no problem communicating using RSLinx Classic, but this defeats the purpose. In RSLinx Enterprise, I can add a SoftLogix controller to the Ethernet driver, but whenever a browse occurs, the Softlogix device disappears, indicating that it is not being seen on the network.
Does anyone have any suggestions, or am I stuck with going the hardware route.
More details on the setup:
RSView SE version 3.2
SoftLogix v.2.1
SoftLogix Winsock32 TCP/IP driver installed.
Both machines (one running SoftLogix and one running RSView Studio) are on the same Ethernet subnet.
I attempted running all software from same machine, with unsuccessful communication as well. I tend to believe that the failure on the single computer is because I did not set up Linx Enterprise and Linx Classic to run side-by-side; not sure if this would help.
Let me know if you have any other questions.
Rick