OMRON sysmacC40K and GT-11 from NAIS!!!

C40K? I would be throwing it away. It has not been manufactured or supported for years. Only a matter of time before it dies.
 
I would really agree with BobB on this one.

However, if you really have your heart set on this, it will require a 3G2C7-LK201-EV1 Host Link Unit.

Hope this will help.
 

Similar Topics

BobB
SMS messaging from an Omron CJ2M-CPU31
Has anyone done SMS messaging from an Omron CJ2J-CPU31 PLC? If so could you help please. Omron here in Oz have not had any experience doing this...
Replies
2
Views
59
lostcontrol
L
I
omron cj2m with scada comunication
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Replies
1
Views
52
IO_Rack
IO_Rack
J
Omron CJ2m cpu33 - reading codes
Hi all, i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info. my unit has an ip address of...
Replies
3
Views
91
chelton
C
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
252
KalvMavin
K
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
4
Views
131
Mihir_007
M
Back
Top Bottom