Have been running RS Links PIC/AIC driver through AIC-Net from PC to SLC 5/03_300 Micro Panelview via another AIC-Net and was using 1747-AIC (Link Coupler) to 2 SLC 5/03's on DH-485 network. Now the 2 5/03's w/Link Couplers are 5/04's. How can you connect Link Coupler to 5/04 ? Do you have to ?? Channel 0 on both configured for DH-485. I will "modify" cables as necessary.
AB DH-485 Network Issue
- Thread starter GSS
- Start date
Mickey
Lifetime Supporting Member
I would replace the Link-Couplers with the AIC+
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1761-um004_-en-p.pdf
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1761-um004_-en-p.pdf
Similar Topics
Good day all. I have an RS-485 topology question. I am hoping for some guidance so that I can make a confident calculation/decision that this will...
I have an allen Bradley system in which there is two micrologix 1200 and two panel view 300 and a Rsview 32 connected on DH485 network with the...
Hi,
i am trying to create an DH485 netwrok which will consist of 2 ML1500 using ACi units for data acquisition back to a pc. i understand how...
Hi,
I am stuck with RS485 network with duplicate node. I changed address of a node by mistake and now cannot talk to any node possibly due to...
Hello All,
I am currently troubleshooting a communications issue regarding a DH485 network. The network contains PLC1, PLC2, and PLC3, all AB...