Mitsu Fx2N-1PG Data Register

I did a search for this with no results, if I missed it please let me know.

I am constantly rotating a dial with a Fx2N-1PG pulse generator.

Because of this continuous motion the currrent position register is constantly climbing.

Does anyone know what will happen once it reaches 32 bit's???

I.E.,....crash, nothing, stop.

Thanks in advance

It should roll over to 0000 with no faults. Try preseting the register with FFF0 and see what happens.

Thanks Keith,

I am pretty sure that this is a read only register as I did already try to right to it. I will try again though.

That did work, I was able to write to that current position register once I had stripped the program down. The register will just roll over.