network messaging

vmikeska

Member
Join Date
Aug 2006
Location
Joplin Mo
Posts
3
I'm programming on a fuji flex nj series that is on it's network. I would like to put message instruction from one plc to the other, I only need one bit and not the hole word. How do I write this
 

Similar Topics

I want to establish a Profinet network in my production plant to connect multiple devices, including a PLC, HMI, and multiple Profinet-based...
Replies
19
Views
557
Greetings Folks, This is my first post after a long gap (almost 13 years) on this forum and i hope that i will get things fixed with your...
Replies
10
Views
236
I have been looking to this and thought I'd ask for input from others before I take it in a wrong direction. The guy who used to set these up...
Replies
9
Views
342
I have inherited a system that uses a Parker ACR9000 motion controller with the Ethernet PowerLink option that it uses to control five Parker...
Replies
5
Views
161
Hi legends, new to this industry but absolutely loving it. I am looking to go online with a ControlLogix PLC, the network is supported by a...
Replies
10
Views
294
Back
Top Bottom