Hello!
One question...
This is what happens:
I configure my hardware configurator, save and compile it, and then I download it to the CPU.
After it is downloaded and the CPU is in STOP because I have still not downloaded my program, I go ONLINE. No problem, it is showing the different states in each slot etc.....Everything is okay.
But if I afterwards shut down Simatic, then I open it back up, open up Harware configurator and try to go ONLINE again, I get this dialog:
Differences ONLINE/Offline
Module Cause
CPU 315-2 DP System Data Differ
Your saved version of the configuration differs from the one in the plc.
I have seen this dialog many times before, but in this case it does not make any sence to me. Because I went ONLINE to the plc right before I shutdown Siamtic, but when I open it back up and goes ONLINE, then I get this. I have not done any modifications in between....
Anybody got an answer to enlighten me
Thank you very much
regards Andreas
One question...
This is what happens:
I configure my hardware configurator, save and compile it, and then I download it to the CPU.
After it is downloaded and the CPU is in STOP because I have still not downloaded my program, I go ONLINE. No problem, it is showing the different states in each slot etc.....Everything is okay.
But if I afterwards shut down Simatic, then I open it back up, open up Harware configurator and try to go ONLINE again, I get this dialog:
Differences ONLINE/Offline
Module Cause
CPU 315-2 DP System Data Differ
Your saved version of the configuration differs from the one in the plc.
I have seen this dialog many times before, but in this case it does not make any sence to me. Because I went ONLINE to the plc right before I shutdown Siamtic, but when I open it back up and goes ONLINE, then I get this. I have not done any modifications in between....
Anybody got an answer to enlighten me
Thank you very much
regards Andreas