Old Square d HMI

jonwayne1951

Member
Join Date
Jul 2006
Location
SC.
Posts
3
I need to replace a square d hmi with a new and avaible product.
needs to have ethernet and drivers for old 350 and 400 series Square D Processors
 
I did a job a while ago where we used Citect as the scada, BUT (here's the rub) we used an interface card from a company called Niobrara (I think I spelt it correctly) that mounts in a PLC slot and basically convetrs Square D protocol to Modbus. Then set Citect up to communicate with an IODevice that had been setup as Modbus TCP/IP. It was reasonably staright forward tos et up and worked well. main reason we used Niobrara and not the PC interface card (SA85 i think) was that at that stage anyway there were issues with getting the OS (Windows NT)to recognise the SA85 card
 
We have that driver on our older HMIs, but don't have it ported over to our G3s yet. If you can't find anything, let me know, and I'll have someone work something out for you.
 

Similar Topics

Has anyone found a way to convert/replace/update the firmware on old Parker TS80xx series HMIs (i.e. TS8010, TS8006, etc) to accept Crimson...
Replies
0
Views
7
Hey all, I am currently working on a depalletizer for a customer and we are doing a hoist upgrade. This is a SLC500 processor and the drives are...
Replies
6
Views
186
Hi, One of my customers has an old fabric tensile testing machine. The IC # AD7501KN of its controller has malfunctioned. This IC is related to...
Replies
1
Views
62
I have an old PLC (circa 2007) consisting of Telemecanique/Modicon/Schneider Electric devices. The system has developed errors and unfortunately...
Replies
2
Views
179
I have a old lathe with a 120 VCA 9.5 AMP motor. Has white, black and red wires. I need to find a way to connect it to a variable speed controler...
Replies
0
Views
89
Back
Top Bottom