fanuc OT series PLC ladder require

manojparmar

Member
M
Join Date
Oct 2006
Location
gujrat
Posts
1


Dear sir
We have purchased CNC Turning Centre from JinnFa Taiwan machine no. JCL32-T10 Dated:- 4-1997 mfg No. 32 T10 01 70 but we have not plc ladder so machine can not Run so please send us immediately plc ladder by email. my email address [email protected]
 
manojparmar said:
Dear sir
We have purchased CNC Turning Centre from JinnFa Taiwan machine no. JCL32-T10 Dated:- 4-1997 mfg No. 32 T10 01 70 but we have not plc ladder so machine can not Run so please send us immediately plc ladder by email. my email address [email protected]
Click to expand...
You will need to go to JinnFa for this information.
 

Similar Topics

S
What options for uploading from an old GE Fanuc Series One PLC?
Got an old machine with a IC610CPU104 CPU. A bit of research told me this is the same as DL305 so DirectSoft from AutomationDirect should work...
2
Replies
15
Views
2,011
strantor
S
M
FANUC series 90-30 PLC
Hello Does anybody have FANUC series 90-30 PLC configuration softwate? I need it . I have a big problem, Please hepl me...
Replies
5
Views
1,751
Steve Bailey
Steve Bailey
D
Ge Fanuc PLC series 90 / 30 331 CPU
Hi guys. Im a total PLC noob. i suspect a dead 331 cpu. Unable to communicate with it using the LM90 start utility. But i could on another CPU...
Replies
4
Views
2,910
Doobs
D
P
GE Fanuc PLC 90 Series and Cimplicity 8.0
Hi All, I have just started using GE PLC and wish to check for some information. I was able to connect to my 90 - 70 PLC with COM1. I would...
Replies
1
Views
2,899
RussB
RussB
P
Regarding gefanuc plc 90-30 series NIU card
Hi, I have gefanuc plc system 90-30 series and proficy m/c edition 5.3.My one NIU card showing LED status are BUS B and IO enable in amber...
Replies
0
Views
1,484
pravingk
P
Back
Top Bottom