adamreid313233
Member
working with ultra 3000 on device net.
cant get the high and low bit outputs to put the right values to the drive.
help please
cant get the high and low bit outputs to put the right values to the drive.
help please
help
- Thread starter adamreid313233
- Start date
jstolaruk
Lifetime Supporting Member
I suspect its the input / output assemblies you've chosen and the scanner's mapping but without knowing that information, its just a guess. I'm working on a (4) Ultra3K Dnet system right know so I might be able to help if you post your RSNetworx configuration.
Similar Topics
Hi Everyone,
i was hoping for a little help with this module. i have data that needs to be read from a different plc through the Modbus plus...
Hello,
I am trying to replicate a piece of logic on the PLC5 onto an SEL RTAC. I am using ladder on SEL and FBD. I am having issue on the ladder...
HOW to communicate with OPTIX and Mitsubishi's Q Series PLC?? PLEASE HELP ME
I'm fairly new to Rockwell software, I've had some basic training in the past but nothing too advanced. My company and I use Reliable products for...
Hi all
I need help on this
As in my project used Schneider TM241 controller.
Now I want to communicate Elite energy meter with controller by...