userxyz Member U Join Date May 2002 Location any Posts 2,768 Nov 8, 2006 #1 How do u need to connect to a CAN-BUS ? It's for using the 'Global Drive Control' tool. I have the USB to CAN converter, but, what to connect, Can-Hi and Can-Lo or ... tnx for help
How do u need to connect to a CAN-BUS ? It's for using the 'Global Drive Control' tool. I have the USB to CAN converter, but, what to connect, Can-Hi and Can-Lo or ... tnx for help
jvdcande Member Join Date Apr 2002 Location Menen Posts 2,178 Nov 8, 2006 #2 Combo, simply connect CAN-L to CAN-L, CAN-H to CAN-H and GND to GND as is shown in this picture. Also don't forget to put a termnation resistor of 120Ohm at both ends of the CAN-bus. Kind regards,
Combo, simply connect CAN-L to CAN-L, CAN-H to CAN-H and GND to GND as is shown in this picture. Also don't forget to put a termnation resistor of 120Ohm at both ends of the CAN-bus. Kind regards,
userxyz Member OP U Join Date May 2002 Location any Posts 2,768 Nov 9, 2006 #3 Hey Thanks jvdcande !!!