vinitch
Member
Hello Friends,
I am using RSView ME to develop a machine application.
I am plotting a graph of stored values w.r.to time repeatedly.
( same graph will be reproduced when PLC receives "Input " signal)
The problem is no two graphs are looking same.Some peaks were missing if you compare two cnsecutive graphs.
The data output is OK only but the way it is showing on graph is not correct.
The value that will be plotted on graph is changing every 250 msec from PLC.
I tried with different update rates in RSView but still problem is there.
Is there any solution to this ?
Regards.
Vinit.
I am using RSView ME to develop a machine application.
I am plotting a graph of stored values w.r.to time repeatedly.
( same graph will be reproduced when PLC receives "Input " signal)
The problem is no two graphs are looking same.Some peaks were missing if you compare two cnsecutive graphs.
The data output is OK only but the way it is showing on graph is not correct.
The value that will be plotted on graph is changing every 250 msec from PLC.
I tried with different update rates in RSView but still problem is there.
Is there any solution to this ?
Regards.
Vinit.