I have a system with s7-314IFM oand two nodes ET200M Dist I/O.
I would like to run diagnostics on one of the nodes. It has two analogue inp modules with 8 inputs each.
I run Dp_SEND & DP_RECV. Then I run DP_DIAG for stationlist. This works perfectly.
Then I run a new DP_DIAG for diagnostics list. This is suppose to give message for new dagnostics data.
Afterwords I run DP_DIAG again for single station diagnostics. It gives 29 bytes of data, but it does not seem to update diagnosis data. I never get messages of Wire-brek e.g.
I have defined diagnosis properties i HW-Config.
How can I get live diagnostics of wire-break etc. in a simple way from the analogue-inputs on a ET200m??
I would highly appreciate all the help I can get!!
I would like to run diagnostics on one of the nodes. It has two analogue inp modules with 8 inputs each.
I run Dp_SEND & DP_RECV. Then I run DP_DIAG for stationlist. This works perfectly.
Then I run a new DP_DIAG for diagnostics list. This is suppose to give message for new dagnostics data.
Afterwords I run DP_DIAG again for single station diagnostics. It gives 29 bytes of data, but it does not seem to update diagnosis data. I never get messages of Wire-brek e.g.
I have defined diagnosis properties i HW-Config.
How can I get live diagnostics of wire-break etc. in a simple way from the analogue-inputs on a ET200m??
I would highly appreciate all the help I can get!!
