Rush!! Need Wiring Info for SJ100

piscis

Member
P
Join Date
May 2003
Posts
241
Rush!! Need Wiring Info for SJ100


I need to send a 4-20ma signal to the VFD for setting the frequency. Can someone please post or email me a wiring example showing which wires I need to connect between the 06 analog card module #F0-4AD2DA-1 and the SJ100 (SJ100-022NFU)



Can you email it to [email protected]
 

Similar Topics

E
Inrush Current for a DC-DC Power Supply
Hello, What's the typical inrush current for a 60W power supply? Is it a factor of 5-10? Is the inrush current based on the maximum rated input...
Replies
2
Views
1,038
Engineer_UA
E
A
Limiting DC Motor In-Rush
I have two 24VDC motors that draw a little under 10A nominal, but the in-rush is over 20A. They are driven with a 20A power supply but on initial...
Replies
6
Views
1,657
Gene Bond
G
C
How to connect AB Micrologix 1100 to a Brush-less DC Motor
Hi, Everyone I am a beginner to PLC. I am currently working on a project to build a door cycle tester. Allen Bradley Micrologix 1100 is used to...
Replies
14
Views
4,256
Dravik
D
R
Recommended Breaker Size and Type for In-Rush Current for Frequency Drives
Good Morning , I just installed some 1 hp Lenze AC Tech 480 Volt Drives. I have seen this with other drives also. I went with a 8 Amp B Curve...
Replies
8
Views
3,842
jraef
J
The Plc Kid
Dc Motor Brush Weirdness
What would cause the brushes in a 250 HP DC motor wear very bad on one side and not the other on a motor that was recently rewound. Also we find...
Replies
6
Views
1,709
leitmotif
L
Back
Top Bottom