Losing communication with scada pc

jalil

Member
Join Date
Jun 2006
Location
jeddah
Posts
13
Losing communication with scada pc
I am using Mitsubishi fx2n plc with mx32 scada. Without any reason communication with plc is losing . when just reset the power off plc get communication again. this is happening daily one time.
Please help me
 
check installation ....

you should see on which condition its happening.
may be tagnames or addressing get interferenced,
or you should reinstall soft ware.....
 

Similar Topics

We have Real Time Automation's 435NBX module, used to access one serial device over EthernetIP network. It seems this device gets stuck and stops...
Replies
12
Views
4,037
I am helping troubleshoot a plant with Modbus communication. We pretty much went through as many connections as we could with limited drawings. At...
Replies
11
Views
4,063
Hello everyone, Currently I am working with a PLC/HMI Horner XL7e over Ethernet/IP communication with an AB ControlLogix, and suddenly the...
Replies
0
Views
1,731
Dear All , We recently upgraded few PLC-5 to CLX(Ver 19.11) and panelview1000e to PV plus 1250( 3nos) . Communication media was changed to...
Replies
0
Views
1,984
Need Help!!! I have a controllogix processor that after 10 days or so the HMI lose communications to processor, I can no longer see the...
Replies
10
Views
5,919
Back
Top Bottom