1756-CNB OK light flashing green

xflipperx06

Member
X
Join Date
Apr 2007
Location
OK
Posts
11
The OK light on my 1756-CNB is flashing, looking in the manual it says that this is caused by noise on the backplane, the card works for programming my panelview through it, can anyone help me get it to stop ?

thanks,
kh
 

Similar Topics

preacher.ca
1756-CNB: Service Request Error: Invalid mode/state for service request
Good day and Merry Christmas Eve. The title's error has been dogging me for roughly a month and today I finally figured out what the issue was...
Replies
0
Views
2,271
preacher.ca
preacher.ca
A
Change 1756-CNB with 1756 CN2
Dear all I have an ALLEN BRADLEY PLC system with a local and a remote rack. On the local rack I have 1756-CN2 and on the remote rack I have...
Replies
2
Views
1,876
AFPC
A
P
Controllogix 1756-CNB/E MSG To 1746-SCNR
Hello all, I'm am trying to figure out how a message initiated from a controllogix processor writes to a SLC 5/04 using control net. Reading the...
Replies
2
Views
1,855
p_logix
P
S
1756-CNB vs 1756-CN2
What's the difference between the two? What's the proper one to use for communicating to a remote i/o rack via controlnet (this is for a Control...
Replies
1
Views
2,624
rdrast
rdrast
E
1756-L71, 1756-RM2 and 1756-CNB firmware revision issue
Hello, Is there any issue in term of the firmware revision for all of these three devices to communicate with each other in one rack? I'm...
Replies
2
Views
4,260
epicnote
E
Back
Top Bottom