jdbrandt
Lifetime Supporting Member
I have a Cimplicity 5.0 installation on a laptop. Opening a project file of a 90-30 with a Profibus Master installed reveals the nodes attached to that master. OK so far. When you go to 'add a node', the TOOLCHEST shows no files, but, the project validates. GE tech support has been no help (yet..there's a case started).
If the project is opened on a different laptop, no worries.
So, this sounds like a problem with the first laptop, and the TOOLCHEST feature. An attempt to reload/repair Cimplicity goes well, until the Motion stuff is loaded, and a goofy error window comes up, ... something about Framework.
Anybody else been suffering through this?
If the project is opened on a different laptop, no worries.
So, this sounds like a problem with the first laptop, and the TOOLCHEST feature. An attempt to reload/repair Cimplicity goes well, until the Motion stuff is loaded, and a goofy error window comes up, ... something about Framework.
Anybody else been suffering through this?