Parker TQ10 Servo Drive

David_Cr

Member
D
Join Date
Jun 2007
Location
Tennessee
Posts
1
Hello,
I have a TQ10 Torque servo drive, and I was wandering can I use it to control the position of a servo, I am new to the servo area and I don't know too much about how a torque drive works?
 
Last edited:

Similar Topics

C
Update old Parker TS80xx HMIs to use Crimson programs?
Has anyone found a way to convert/replace/update the firmware on old Parker TS80xx series HMIs (i.e. TS8010, TS8006, etc) to accept Crimson...
Replies
0
Views
89
CageFreeBMW
C
T
Parker eurotherm SSD 637 servo drive software
Dear all, we have a couple of SSD 637 servo drives that need to communicate trough easyrider. On the parker website you can download easyrider...
Replies
0
Views
510
tvgids
T
S
Communication of Parker SSD 590+
Hy everyone, I have Parker DC Drive (590+). in ints manual there is mentioned about P3 port which is based on (RS-232) communication. I want to...
Replies
0
Views
905
SaadJanjua
S
ronny_resistor
PARKER 6055 LNET and Controllogix
So my distributor convinced me to try this card out instead of the Ethernet I/P card this is for the 690 and 590 drives that allow for...
Replies
3
Views
2,233
ronny_resistor
ronny_resistor
S
pinout for Parker 690+ programming cable?
I need to emergency fabricate a cable to program a Parker 690+ VFD. Part # CM351909 I believe. RJ6 on one end, DB9 on the other. I cannot find the...
Replies
1
Views
2,291
strantor
S
Back
Top Bottom