Hi,everybody,have A Problem With An Old Izumi-idec Plc On An Auto-hacksaw-fa1/j.the Error Light Is On Continuously And There Is No Operation In The Manual Setting. Can I Bridge Out Any Terminals To Achieve Manual Operation? Who Would Have Any Software,leads Etc To Reboot The Unit Or Do I Throw It In The Bin And Install A Brand New Unit? Suggestions Please.
Henry
- Thread starter HWELECT
- Start date
ToolGuyFred
Member
Do you know what model the PLC is?
Do you have a hand-held programmer or PC-based software with which to interrogate the PLC?
For more information try:
http://www.idec.com/gben/products/Catalogs/Software/WindLDR/overview.html
I have instructions and tutorial for the WindLDR programming package if that's any help?
Do you have a hand-held programmer or PC-based software with which to interrogate the PLC?
For more information try:
http://www.idec.com/gben/products/Catalogs/Software/WindLDR/overview.html
I have instructions and tutorial for the WindLDR programming package if that's any help?
Dear TooIGUY FRED,
Thanks For Your Reply,we Returned To The Job Today And Removed Both Input And Output Modules,tested The Power Supply And Discovered A Fault Within The Fa1/j Output.changed Power Supplies And Rebooted The System.the Programme Was Secure As The Plug In Module Is Brown In Colour.used Hand Held Controller To Reset Output 701 And 702.
Tested Operation And All Is Well.
Many Thanks
Henry
Thanks For Your Reply,we Returned To The Job Today And Removed Both Input And Output Modules,tested The Power Supply And Discovered A Fault Within The Fa1/j Output.changed Power Supplies And Rebooted The System.the Programme Was Secure As The Plug In Module Is Brown In Colour.used Hand Held Controller To Reset Output 701 And 702.
Tested Operation And All Is Well.
Many Thanks
Henry
Last edited:
ToolGuyFred
Member
Pleased to hear you have it sorted.