Motion Control Problem

zampeddy

Member
Z
Join Date
Jul 2007
Location
italy
Posts
1
I'm using an OMRON MCW151 board with a SIGMA II servo drive to control a cilinder with a cutter that chases a conveyor belt.
If i use only a simple MOVELINK there is no creep out of synchronisation but if i cut the single MOVELINK into 3 differernt MOVELINK the axes will slowly creep out
of synchronisation.
The Motor ratio now is exact 5,25!
someone can halp me or give a suggestion..
Thanks
 

Similar Topics

S
controllogix Motion Control problem
I have some problem to excute MAM and MAJ, sometimes it shows "execute on an axis whose servo loop is not closed" and MAM error is 5: servo off...
Replies
3
Views
5,772
drawson
D
I
Controllogix T300 Motion Control Setup Problem
Hello all, I am presently trying to setup a motion control project with a Logix 5563 processor and a Siemens 6RA70 DC Master using a...
Replies
8
Views
6,124
IPSIBilly
I
E
Allen Bradley motion control problem
Hi I am using the 2-Axis motion control module of Allen Bradley model M02AE, which is used in a Controllogix chassis. One of the motors...
Replies
6
Views
6,305
Peter Nachtwey
Peter Nachtwey
H
Motion control use torque loop in Rockwell Studio 5000
I have always controlled servos in Rockwell motion using position loop. I have an application where one process will push against a servo...
Replies
3
Views
271
robertmee
R
D
Motion control parameters
How do I adjust motion control parameters using Logix Designer? Such as: motion axis stop I will make an adjustment like changing the...
Replies
1
Views
321
chavak
chavak
Back
Top Bottom