MNJ96
Lifetime Supporting Member
hi everyone
this is in conjunction with a active thread i have going SLOW PANELVIEW . i changed my slc/03 program to enable df1 pass thru option to my connected panelview 550 . also changed the max node address from 31 to 4 . it worked fine being able to connect to the panelview thru the pass thru but after i changed to max node addresses and downloaded the program. now in linx i no longer can see the panelview and i am showing the same processor and program on all 32 nodes . if i delete a node it comes right back and i also can not stop or delete the df1 driver despite all my efforts has anyone seen this before ?
thanks
this is in conjunction with a active thread i have going SLOW PANELVIEW . i changed my slc/03 program to enable df1 pass thru option to my connected panelview 550 . also changed the max node address from 31 to 4 . it worked fine being able to connect to the panelview thru the pass thru but after i changed to max node addresses and downloaded the program. now in linx i no longer can see the panelview and i am showing the same processor and program on all 32 nodes . if i delete a node it comes right back and i also can not stop or delete the df1 driver despite all my efforts has anyone seen this before ?
thanks