S7 and OP7

drummerflame

Member
D
Join Date
Oct 2005
Location
Akranes
Posts
2
Hi there.I´ve got a problem with an S7 program.I´ve got a output coil and the adress above the coil says: #PrintedOK.The function of this part of the program is to print a screen on a OP7 panel.Where can I find what´s behind this adress?

Best regards

Logi
 
Fb

Hello,

It is probably variable in the the function block. If you want to see what is "behind" this, to see local adress look at the example below:

FB8.JPG
 

Similar Topics

B
Siemens OP7 program conversion to Delta DOP107BV
I have converted a Siemens OP7 program to a new Delta DOP107BV. It is all working as expected except for the timer values. I am using MW36 as the...
Replies
6
Views
937
bambam79
B
B
Siemens OP7 $620 Programming error
I have a customer who had a faulty Siemens OP7. They sourced a replacement. They have the original program. I downloaded the program to the...
Replies
10
Views
2,528
sigmadelta
S
E
Siemens OP7 OLD Hmi Terminal
Hi Guys, Hoping we still have some Siemens Old hardware Gurus on here. We are trying to support one of our long time customers. Who have obtained...
Replies
4
Views
907
sigmadelta
S
Z
Dead simatic op7
Hi all! I have this old Siemens Simatic op7 panel I need to rescue. At boot nothing appears on lcd, backligth and all led's are on. Does not...
Replies
0
Views
785
zanor
Z
P
Looking for old firmware for Simatic OP7
Hello everybody, I am actually trying to bring an old machine back to life. It is set up by a Simatic S5 CPU (95U) and a Simatic OP7. The old OP7...
Replies
6
Views
2,589
PM_UzK
P
Back
Top Bottom