manmeetvirdi
Member
Hi there
I have got panl PC 577
Its communicating with the PLC this was confirmed by pinging
Now I have installed the WinCC scada on the panel PC
Problem is in Set PG/PC interface i need to have the option of TCP I/P which iam not getting
Through ADD/REMOVE option also it is not showing the TCP/IP option.
What can be the reason??
I have re installed the network drivers but even then its showing up in PG/PC interface
I have got panl PC 577
Its communicating with the PLC this was confirmed by pinging
Now I have installed the WinCC scada on the panel PC
Problem is in Set PG/PC interface i need to have the option of TCP I/P which iam not getting
Through ADD/REMOVE option also it is not showing the TCP/IP option.
What can be the reason??
I have re installed the network drivers but even then its showing up in PG/PC interface