bsprowls
Member
Is there a straight forward way of telling if a PLC5 has an eeprom on board? I have a 5/20 and a 5/40 and a 5/80, and I do not want to take them out of the racks.
Eeprom present?
- Thread starter bsprowls
- Start date
Eddie Willers
Member
The PLC-5 "Enhanced" processors (includes the 5/20, /40, /80) have a hinged door on the front of the controller that holds the memory module.
The memory module sticks out a bit from that door so it's easy to see.
The memory module sticks out a bit from that door so it's easy to see.
Mickey
Lifetime Supporting Member
Look under the rectanular opening on front of controller. See pics
Last edited:
Similar Topics
"(S44) PLC requested action has failed"
Result when WRITE the RAM program to the EEPROM.
No pre-confirmation message first.
VERIFY fails too...
Hello
I have a couple of processors a 5/01 and a 5/02 both with eeproms
When i try to load program onto either eeprom with either processor a...
Hi all, yesterday I was at a customer site doing a PM and after making a couple of minor mods to the program, I went to back it up to EEPROM (yes...
I recently had a 5/04 lose its program for what I'm atributting to a cheap battery that was installed 6 months ago so installed a EEPROM.
I...
When I try to save ladder logic from the RAM of Cutler-Hammer D100CRA40 PLC to EEPROM (I tried both D100EE10 and D100EE28), I'm getting Error 25...