BillRobinson
Member
Can anybody suggest a device that would split a modbus RS-232 signal from a modem to two different PC's?
RS-232 Splitter
- Thread starter BillRobinson
- Start date
SLC_Integrator
Member
Black Box make both a hardwired DB25 'Y' adaptor and a software-switched electronic splitter.
Remember youll either have to stick with one Modbus Master or synch two masters so they take turns polling tho.
Remember youll either have to stick with one Modbus Master or synch two masters so they take turns polling tho.
SNK
Member
Are you looking to snoop? Or are you planning on full communications?
Similar Topics
Anyone have any experience with using a 1747-DPS2 device? Bascially, have a Micrologix 1000 where the round port is being used by the HMI (Panel...
Has anyone successfully used one of these units?
We have an application that uses the Channel 0
port for a HMI device. Occasionally we would...
I have a piece of equipment that is operated by a PanelView Plus 600 HMI touch screen via RS232 into a Micrologix 1500 PLC.
I am trying to...
i have an device which can support serial (RS485,RS232),CAN protocol . i want to connect it to an existing MIB 1553B bus ,what device will I need...
Hello:
I have to connect a RS232 Modbus RTU slave that only has Tx, Rx and GND signals to a Modbus RTU master.
However, all RS232 to RS485...