Rockwell
- Thread starter oneill
- Start date
Ken Roach
Lifetime Supporting Member + Moderator
Well, thousands of people use RSView32. I presume that you have posted an error message.
You are in dire need of this:
http://www.catb.org/~esr/faqs/smart-questions.html
You are in dire need of this:
http://www.catb.org/~esr/faqs/smart-questions.html
Operaghost
Member
Straight from the Rockwell Knowledgebase
Cause:
The VBA Project has a reference to an Object Library that is not installed on the computer. This is most likely to occur when sharing projects between computers.
Solution:
Open the RSView32 project on the computer that originated the project and record all referenced Object Libraries in the VBA IDE. Make sure these Object Libraries are all properly installed on the destination computer.
OG
Cause:
The VBA Project has a reference to an Object Library that is not installed on the computer. This is most likely to occur when sharing projects between computers.
Solution:
Open the RSView32 project on the computer that originated the project and record all referenced Object Libraries in the VBA IDE. Make sure these Object Libraries are all properly installed on the destination computer.
OG
Operaghost
Member
You really need to post better questions..............
Is this a NEW message? Is this occuring AFTER the VBA message?
PLEASE help us help you.
OG
Is this a NEW message? Is this occuring AFTER the VBA message?
PLEASE help us help you.
OG
Operaghost
Member
OK..........
Did you read the post above from the Rockwell Knowledgebase? It sounds like the projects you are trying to open were copied from another computer, but not all files got copied. That would explain why a new app does not get these errors.
Go to the machine(s) where the originals are located. Use the Transport Utility to copy all files and folders.
OG
Did you read the post above from the Rockwell Knowledgebase? It sounds like the projects you are trying to open were copied from another computer, but not all files got copied. That would explain why a new app does not get these errors.
Go to the machine(s) where the originals are located. Use the Transport Utility to copy all files and folders.
OG
Similar Topics
I'm working with a project that contains some routines in ST but mostly in ladder. Am I correct in assuming this 'rung':
DB1001DO._01AV55_OPEN :=...
I noticed in Rockwell AOIs, they add a BOOL Output parameter at the end of the "Parameters" list of each AOI that carries the same name as the...
Hi
I have a couple of hmi panel view plus 700
Hmi and we keep dropping coms /stars in the data boxes
I’ve checked the plc and unmanaged switch...
Hello! Hope you are great. I need to make a change in a PLC with ladder logic. I will mount a analog valve and I need to control it in ramp up...
I am very new to Modbus and the industry, so forgive me if I am missing something obvious. I have known Modbus register addresses coming from a...