AD D2-HPP "No On Stages" mgs<???>

Gear:
Automation Direct Handheld Programmer, D2-HPP

Age:
About a year old.

Problem:
Screen shows the following messgage: NO ON STAGES (and nothing else..)
Cannot go online to a DL105.

Where I already looked:
In the book, in error codes. Nothing.

Solution:
Reload program (from DirectSoft), and reconnect
HPP. All is well.

Question:
What is/was this message, what caused it.

I haven't a clue JD...

Please post this question over at the A-D FORUM.

One of the tech guys might have an answer (or at least like to know about it!)...

beerchug

-Eric

ok, I did that

Thanks, I did that. We'll see.
I also did a quick search on the customer forum, and found nothing.

Yeah JD, I looked around a little too (FAQs, manual, etc.)...

I don't think the handheld was very popular. It's sooooo much easier to just use DirectSOFT!...

Give it a few days over there. I don't think the tech guys stop in EVERY day...

beerchug

-Eric

You can get this to display on the HPP by pressing the Stat key then selecting Stage Monitor with a program that either has no active stages or on a non-stage program.

You can clear it by pressing the clear key a few times.