How to replace processor type in existing slc program

Peacemaker · Oct 18, 2007

Hi there,
I am going to replace processor type from SLC 5/03 to SLC 5/04 in the exixting program offline because I am going to use SLC 5/04 instead SLC 5/03 in the control panel. But I cannot access to the processor field in processor and I/O cofiguration page of RSlogix500. I can change I/O module, though. Any help would be much appreciated.

Richard

JesperMP · Oct 18, 2007

Try the "Controller Properties" in the project tree. Under the "general" tab there is a "Processor Type" selector.

TConnolly · Oct 18, 2007

Here is a picture

Peacemaker · Oct 18, 2007

Thanks a lot guys.

mordred · Oct 18, 2007

it will prompt you to resize data tables click the check box then apply

OkiePC · Oct 18, 2007

mordred said:
it will prompt you to resize data tables click the check box then apply

Be careful with your choice here, I usually uncheck the Resize Data Tables option, so RSLogix doen't steal my spares...

Paul

mordred · Oct 19, 2007

Does it actually reduce your memory resources?

How to replace processor type in existing slc program

Peacemaker

Member

JesperMP

Lifetime Supporting Member + Moderator

TConnolly

Lifetime Supporting Member

Peacemaker

Member

mordred

Member

OkiePC

Lifetime Supporting Member

mordred

Member

Similar Topics