Modbus for Vipa PLC

Schtiel

Member
Schtiel
Join Date
Oct 2006
Location
West
Posts
92
I have problems with CP240 module for VIPA. Has anybody used it?

I need to implement MODBUS SLAVE MODE. Should I put any additional code to my program or it is enough just to configure CP240 module?

Please help me.
 

Similar Topics

A
Modbus RTU on VIPA CPU314SC with TIA Potrtal 12
Hi All. Could you please help me with this Modbus I've been trying to set up for the last 10 weeks!!! I have an VIPA CPU314SC and trying to...
Replies
1
Views
2,044
KalleOlsen
K
Voltimus
IDEC PLC to PLC modbus communication
Apologies for not being the best IDEC programmer. I recently was doing some inspections on a site that had 3 FC6A IDEC processors. The issue is...
Replies
0
Views
34
Voltimus
Voltimus
Rsflipflop256
Setting up a modbus network on a DL262 Directlogic PLC with Siemens LMV 3 Burner controllers as slaves, eight of them, with OCI 412.10 Interface
Good morning fellow sea captains and wizards, I am being asked to do the above and obtain 4 values from each slave, I know about the MRX and MWX...
2
Replies
20
Views
200
Rsflipflop256
Rsflipflop256
S
Modbus communication help
Hi all I need help on this As in my project used Schneider TM241 controller. Now I want to communicate Elite energy meter with controller by...
Replies
3
Views
92
Corsair
C
T
Modbus registers
Good day guys. I have a third party device with its Modbus registers which I want to copy/set up on a plc because I need to convert my Modbus tcp...
Replies
3
Views
119
Corsair
C
Back
Top Bottom