panel view uploading problem

Reset the Terminal ​

Resetting the terminal re-initializes the PanelView terminal (same as
​

cycling power).
​

Follow these steps to reset the PV300, PV300 Micro, PV550 (keypad,
​

keypad and touch) or the PV600 (keypad, keypad and touch)
​

terminals.
​

• Simultaneously press the Left arrow , Right arrow , and Enter
​

↵ keys. The terminal performs its powerup sequence.
​

The sequence in which keys are pressed (while running an
​

application), determines what appears after the reset.
​

• If you press the Left and Right arrow keys before the Enter
​

↵ key, the Configuration Mode menu appears.
​

• If you press the Enter ↵ key before the arrow keys, the terminal
​

runs the loaded application.
​

Follow these steps to reset the PV550 and PV600 (touch only)/
​

PV900/PV1000/PV1400 terminals.
​

1. ​

Use a narrow, non-conductive tool to press the reset button.
​

The terminal performs its powerup sequence.
​

TIP ​

​

If the Left or Right arrow keys on the PanelView 300
​

Micro are assigned as function keys, you must use the GoTo
​

Configuration Screen button.
​

ATTENTION ​

​

Use a nonconducting object to press the Reset button. Do
​

not use a conducting object such as a paper clip that may
​

damage the terminal. Do not use the tip of a pencil;
​

graphite may damage the terminal. The normally-open,
​

momentarily-closed Reset button is designed for only 1.3 N
​

(0.29 lb) operating force. Use of excessive force may
​

damage the button or cause it to stick.
​

On the PV550/PV600 touch screen terminals, the Reset button is on the right, below the Memory Card slot.

Click to expand...