problem with decimal point

pullareddy

Member
P
Join Date
Nov 2007
Location
kkd
Posts
13
In simatic S7 300 program (STL) if multiplication constant put in decimal point I am not get any out put like 13.0213 mention as below



If I put 13 only out put is coming



But if I am using ladder it is taking decimal point also ,why it is not taking in STL



L PIW 272

L 13.234

/R

T DB14.DBD 0
 

Similar Topics

T
GE Fanuc adding decimal values to constant problem
Hi, There is a compare block being used 1100 times to compare variables to a constant value -999. The problem is that the GE is changing the -999...
Replies
2
Views
1,858
treefort
T
JesperMP
Decimal separator symbol problem.
Hi all. I have a strange problem with VBS scripting that prints values to a CSV file. It normally works well if only the decimal separator is...
Replies
3
Views
2,339
JesperMP
JesperMP
Z
Problem getting decimal value to ineger file using NI8
m using AB SLC-500 PLC and the processor is SLc 5/03.i want to implement the PID control on the bytronic inverted pendulum using this PLC.As a...
Replies
4
Views
1,978
zahidraza1212
Z
Z
Problem getting decimal value to ineger file using NI8
m using AB SLC-500 PLC and the processor is SLc 5/03.i want to implement the PID control on the bytronic inverted pendulum using this PLC.As a...
Replies
9
Views
2,873
Mickey
Mickey
H
problem in Eplan P8
On all pages of my project i have a lot of information, texts and details that should not not be shown. I can remove them for each part apart from...
Replies
0
Views
31
Haytham_93
H
Back
Top Bottom