Panasonic PLC Communications

eForce · Dec 2, 2007

Hi, I have 2 FP2 processors on Nano Racks with ET1 Lan Units installed. Can anyone help me get these to communicate.

All I want to do is have one PLC read 3 inputs from the other PLC.

Arlie · Dec 2, 2007

heya, what you can do is use 3 outputs from the one plc as inputs to the other , let me know what it is you are trying to do and I will try to help you out, what software are you using FPWINPRO or GR

eForce · Dec 2, 2007

Oh normally I would but the PLC's are on opposite sides of the factory and connected through an Ethernet cable.

I'm using FPWin Pro

Arlie · Dec 3, 2007

give me a few and I will see what I can come up with.

eForce · Dec 3, 2007

Anything you can come up with would be appreciated.

Thanks in advance.

Arlie · Dec 3, 2007

ok have you called panasonic tech support?? I think they can help you alot better than I if you need there numnber let me know I will give it to you

eForce · Dec 3, 2007

I have actually, they just sent me some ample programs but they are in FPWinGR and I have FPWinPro.

Arlie · Dec 4, 2007

import them into PRO, just open pro first, create an empty project, then import it.

just use direct addressing

eForce · Dec 4, 2007

well I'll be!!!!

Thanks bud.
I'll have a look here and see what I can learn

Arlie · Dec 4, 2007

Hey no problem, hope you get it, glad I could help for once

Panasonic PLC Communications

eForce

Member

Arlie

Member

eForce

Member

Arlie

Member

eForce

Member

Arlie

Member

eForce

Member

Arlie

Member

eForce

Member

Arlie

Member

Similar Topics