Omron cji md232 Mil Conector

rgmiles

Member
R
Join Date
May 2006
Location
Mountain ash
Posts
53
Hi Guys.
I want to use an Omron 32 point card .
I need the pinout diagram for the mil 20 connector.
Does anyone know where i can find this??
I have searcherd the Omron site to no avail.
Many Thanks
Bob
icon7.gif
 

Similar Topics

J
Omron CJ2m cpu33 - reading codes
Hi all, i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info. my unit has an ip address of...
Replies
1
Views
25
chelton
C
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
216
KalvMavin
K
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
4
Views
130
Mihir_007
M
A
Omron cj1m ETN cpu11 connection with NT631C
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...
Replies
12
Views
236
IO_Rack
IO_Rack
K
Omron AD081-V1 Analog Input Card Calibration (Offset & Gain Adjustment)
Omron AD081-V1 Analog Input Card Offset & Gain Adjustment Entering Adjustment Mode 1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
Replies
0
Views
84
Ko Lin
K
Back
Top Bottom