New B from PA

Mach

Member
Mach
Join Date
Dec 2007
Location
PA
Posts
5
Hey guys, I just wanted to introduce myself. I don't have much PLC experience. I currently work E&I. I havn't programmed a PLC for a few years. Seems like there is so much more stuff out there than I thought. I am looking to expand my experience with Automation equipment.

Ken
 
Hello, If you dont mind my asking what part of PA are you in? I am in the Northeast section. Luzerne, Columbia, Montour areas.



Mach said:
Hey guys, I just wanted to introduce myself. I don't have much PLC experience. I currently work E&I. I havn't programmed a PLC for a few years. Seems like there is so much more stuff out there than I thought. I am looking to expand my experience with Automation equipment.

Ken
Click to expand...
 
Welcome - you'll get lots of good advice here. Post often!

Mach said:
Hey guys, I just wanted to introduce myself. I don't have much PLC experience. I currently work E&I. I havn't programmed a PLC for a few years. Seems like there is so much more stuff out there than I thought. I am looking to expand my experience with Automation equipment.

Ken
Click to expand...
 
mrtweaver said:
Hello, If you dont mind my asking what part of PA are you in? I am in the Northeast section. Luzerne, Columbia, Montour areas.
Click to expand...

I am near Johnstown, Ebensburg. Not much around this area as far as work. I usually travel for work. I am currently working near DC for a few months. I'm looking to find a fulltime job near Raleigh or somewere warm. I also thought about going on my own as an independant contractor. I kicked around hourly rates, I seem to be coming up with $120/hr I don't understand how some guys can work for $80/hr unless they are busy 40 hours a week.

Thanks for the welcome guys

Ken
 
Back
Top Bottom