GertThePLCGuy
Member
Trying to configure a 1756-CNB/E module in a Logix 5000 system version 13.04 but this module is not listed in the I/O configuration table. I'm not prepared to jump to version 16, so does anybody have any suggestions?
RSLogix 5000 ver13.04 with a 1756-CNB/E
- Thread starter GertThePLCGuy
- Start date
widelto
Member
If you system is a new one, I think is better to get new version 16 and use it, with it you take better support ( all the new modules are included) and you can start using add-on instruction.
hope this will help.
hope this will help.
GertThePLCGuy
Member
OP
thanks for your help!
Similar Topics
Hi folks, in the alarm manager of Rslogix 5000, the tag-based alarm has been created. But when I tried to change the condition, it was found the...
I am completely stuck on building a ladder program that requires a start button to be pressed 3 times to turn on motor 1. Then motor 2 starts...
First off, I'm a hobbyist-level programmer, and this program isn't controlling anything anything that could even remotely be considered "life...
Hello all,
I have a question in regards to RSlogix 5000. I am having issues with the program force closing when I try to make online edits. We...