How to config compactlogix DF1 with DL3500 converter
- Thread starter tx4129
- Start date
Ken Roach
Lifetime Supporting Member + Moderator
Configure the DL3500 with EquusTek's software utility:
http://www.equustek.com/downloads.php
Then configure the serial port on your CompactLogix for the same data rate (default 19200 baud), serial framing (8 data bits, 1 stop bit, No Parity), and error checking (default BCC).
http://www.equustek.com/downloads.php
Then configure the serial port on your CompactLogix for the same data rate (default 19200 baud), serial framing (8 data bits, 1 stop bit, No Parity), and error checking (default BCC).
Similar Topics
I might be missing something simple here but we've set some scaling up on our analogue input cards (4-20mA ranged HighEngineering = 100...
Hi,
The point io AO card OE2C will not take any output value. It also resets its configuration (edited in RSNetworkx for DeviceNet) every time...
Hi,
We have an application that has a device that goes through a reboot (appears un-graceful)
What then happens is the MVI module appears to hang...
Hi all,
I have some difficulties with programming a NAT config in my Scalance SC636-2C
When programming the NAT-table i'm not able to reach my...
Hello Folks,
Has anyone configured a Momentum high speed counter on Unity 13.1.
We need the wiring diagram for Momentum High speed counter and...