s7-200

aladawi1

Member
Join Date
Oct 2007
Location
jordan
Posts
5
Hello:

I am working in steel structure factory, and we have wagner drilling with sematic

s7- 300 control system .actualy we have some problems in our machine .

On my PC i have s7-200 software , can i join the the s7-300 to PC with s7-200

software and how i can do it.(the connection i am using to CPU is MPI.

with best regards
 
S7-200 and S7-300/400 are two completely different types of PLCs. The software package for S7-200 is called Step7 MicroWIN, for S7-300 and -400 you need STEP7 or STEP7 Professional.

The answer is plain and simple: no, you can't use your software with S7-300.

Kind regards,
 

Similar Topics

Hello, I am in possession of a WAGO PFC 200 750-8216 which I was successfully able to set up as a Modbus RTU Master to a slave device using...
Replies
0
Views
47
Hi, I have a 1214 on ip 192.168.0.100. This is connected to other modules through a switch on same network. I need to connect this to a company...
Replies
1
Views
97
Hi. I’m trying to upload program from existing PLC S7-1200. Create new project in TIA v15.1 then upload. After upload successfully, go online but...
Replies
5
Views
145
Hi all, I am trying to do Modbus communications via the CB1241 RS485 Communication Board on a Siemens S71200 PLC. I am using a 1215C CPU. After...
Replies
6
Views
183
Dear Friends, I have few Profinet slaves connected to S7-1200 over Profinet. I wish get alarms and disagnostics from the devices. (IO-Link...
Replies
3
Views
138
Back
Top Bottom