WinCC 6.2 Help...Regarding WinLC

macs_plc

Member
Join Date
Jan 2008
Location
Nagercoil
Posts
120
I have connected PLCSIM and WinCC...
It is working and if i change values from plcsim corresponding values changes in WinCC

But when i tried to change from wincc nothing happens .. i have already refered this document...
http://support.automation.siemens.c...delled=&lang=en

and i have done all those things... but i cant connect to controller .....

i have shown the error message which comes out when i try to connect
What is the problem dear Experts ??????

http://www.plctalk.net/qanda/uploads/errr.JPG
 

Similar Topics

Hi, Im trying to open an old old Siemens WinCC project. It doesnt have to run i just want to look at the project in WinCC explorer. Its...
Replies
2
Views
517
Hello to everyone. I change the value of a "PQW" with a button in Wincc flexible. The code of the button is defined as M102.0. Value reset...
Replies
10
Views
4,519
Hi, I'm not a siemens expert but we recently converted an old siemens PC into a virtual machine so we could run it on modern hardware. It was...
Replies
16
Views
7,772
Hello Guys, I am trying to test HMI in TIA Wincc Professional V13 with my virtual machine with Rslogix emulator. Wincc is using OPC to...
Replies
0
Views
1,384
hi guys, I know some people winch a little when the topic of password recovery crops up. The engineers on site have forgotten their password to a...
Replies
18
Views
19,317
Back
Top Bottom