I have a zen 10c1ar

I am trying to program this but really having a hard time.
What I need it to do is to turn on switch a,b,c, while switch d is off
then leave a on turn d on while turning b,c off

then i need it to leave a on b on c off d off and close e.

i would also be looking to add time to the functions perhaps 30 sec. for the first set then 90 sec then 30 for the final.

I would really love some help on this.
If you need more info I have it here.

Thanks

ZEN's are fun little micros.
I am guessing switch a,b,c,d are outputs?
usually switches go to inputs.
I am stuck doing the grave thing this week, I will help you when I get there in a couple of hours.

Post the details of your assignment.

I have included the schematic below,
what I need is for a one button push operation, if you look at the schematic you will see that it is a toggle switch.
I need to make it a one push start .

So I will need 9 and 17 to close
28 and 21 to close
21 and 22 to close
2a and 5 to be open

after the dumper gets to the top

I will need the packer to start , with the dumper staying at the top.
To start packer I need 9 to 17 to stay closed
28 to 21 to open
21 to 22 to open
2a and 5 to close

after say 90 seconds I need the dumper to come down
so I need 9 and 17 to stay closed
28 and 21 to close
21 to clsoe with 23 and then it is open from 22
and 2a and 5 to open
Then the unit shut down until the button is pressed .

Try This

I guessed at some unknowns, It was a pain with only 4 outputs.

Jpeg for comments

Well I was going to post a pic of the logic so anyone could make suggestions but the pic didn't print. I tried to do it again but I get a message that it is already there. sorry

Thanks !!!!
Maybe PM me your address and I can send you a little something.