One of my project is based on controllogix and Factorylink 7.5, I am wondering how the Ethernet 1756-Enet connected with Factroylink Server, which driver should we use? Is there any documents about the Communication driver and how to config the interface? Thanks.
AB Controllogix and Factorylink 7.5
- Thread starter wilsonzhu
- Start date
Similar Topics
One of my project is based on Factorylink 7.5 (as Scada) and Controllogix (as PLC). I should config the communication between factroylink and...
Why does the controllogix redundancy modules use a single mode fiber vs multimode fiber?
Hello,
I have two 16 point input cards and 1 16 point output card showing module faulted on my IO tree in Logix Designer.
The fault code is...
Hello,
My associate and I are trying to sync up two ControlLogix racks (7-slot chassis) with identical modules. We are able to see the secondary...
Trying to setup a message read via Ethernet.
I have the path setup as 1, 1, 2, 192.168.66.10
I get an error code 1, ext err 315.
I am beating...