Ethernet/IP , no i/o control?

You can connect it to a PanelView and it will work. The PanelView can access data using explicit messages, just like a computer would using RSLinx. In fact, I'm not sure you can even configure a PanelView to act as an Ethernet/IP I/O drop. I've never tried that.

Keith
 

Similar Topics

An outside contracting firm designed a machine for our company. There are several devices connected through Ethernet/IP. This includes a Panel...
Replies
4
Views
184
Hey everyone! I'm searching for an example demonstrating how to program in Studio 5000 speed control of a PowerFlex 525 drive via Ethernet. While...
Replies
1
Views
639
I have a system that is using TCP sockets. There are 5 connections between the Ethernet card and the end devices (smart conveying system)...
Replies
0
Views
691
I am trying to exchange data (N registers) to and from a Control Logix PLC. I am programming the messages in the Control Logix program, to...
Replies
7
Views
2,126
Hi I’m having issues figuring out how to connect a Schneider ATV930 to Control Logix PLC. Can’t figure out the Connection Parameters, I used the...
Replies
2
Views
1,168
Back
Top Bottom