Analog out SF, Siemens plc's

orense

Member
O
Join Date
Apr 2006
Location
Norway
Posts
196
Hello gentlemen

I have got a small rack with a CPU 313C and some digital and analog cards...
The problem is that the analog out card has the SF light lit. When I go online in hardware config
and look at it, there is no SF in hardware config. It says module available and OK.
Even so, I still have the light on...
I have checked the order number, it is correct
When I turn the CPU to STOP mode, the light goes of...
Any ideas??

thanks

Andreas
 

Similar Topics

D
Siemens PLC & Phoenix contact remote i/o analog card
Hello, new to the forum, been here over the years on and off, but now I am more involved at work so I run into more difficult problems.... Maybe...
Replies
5
Views
3,962
nonuke
nonuke
C
Analog scaling siemens plc s7300
Hi all, Does any body have some literature on how to scale the analog input signals e.g level tank control using a pressure...
Replies
2
Views
6,237
nonuke
nonuke
K
Analog Modules in siemens S7 400 PLC
Hi..all..I am a newbie in this field..trying hard to acquire some good knowledge in this field. While studying about the analog input modules in...
Replies
2
Views
5,417
Kakka
K
K
Analog Modules Used along with siemens S7 400 PLC
Hi..all..I am a newbie in this field..trying hard to acquire some good knowledge in this field. While studying about the analog input modules in...
Replies
1
Views
5,769
dchartier
D
B
analog output fluctuation from siemens plc
Dear sir, we are getting fluctuated output from plc even though batching controller is showing constant value after batching completion...
Replies
1
Views
3,170
dchartier
D
Back
Top Bottom