jimcav
Member
i have a mircologix 1500 lrp using df1 on channel 1 and i want to talk to a panel view plus using df1 drive i need the pin outs to make a cable
Thanks
jim cav
Thanks
jim cav
micrologix 1500 to panelview
- Thread starter jimcav
- Start date
Mickey
Lifetime Supporting Member
Any 9 pin straight thru cable will do.
See PDF below (ML1500 Channel 1 same as SLC 9 Pin)
See PDF below (ML1500 Channel 1 same as SLC 9 Pin)
Last edited:
Similar Topics
I have been working on this for a while now and I can't seem to get it. I was finally able to view the 1500 on the PanelView under the serial...
Hello,
Well, after fighting thru comm and cable issues from pc to panelview and pc to plc finally communicating with each separately. I have...
Hey guys!
I need to communicate a PV550 with a Micrologix 1500 ASAP, but the 1761-NET-AIC doesn't seem to be working.
I was wondering if the...
So I figured I'd start off by saying I love this place. I never registered, but frequent this place often to read up on the little tricks to get...
This is just a general question, it is possible to connect a micrologix 1500 to a panel view (550, 600 etc), by using a 1761-NET-AIC adaptor? If...